Or, the nut might not cover the bulk of the split washer well so the solid washer is used as a pusher: Nut O C material Headīut, more generally, look at each component and how it relates to the basics. So I suppose the solid washer goes on next to the surface being passed through, and the split washer after that. In this case, the little spring may need another stable surface on one end, because the hole in the thing is larger and it would not fit flush against the material, but might get the cut end fouled into the hole. It provides pressure that you tighten against, rather than squeezing the material being bolted. The split ring is actually a very short spring. The flat washer always goes against the surface to prevent damage by the lock washer. Washers may be used to make a hole smaller, and/or to modify the surface against which the head or nut rubs against. 49078: If you are using lock washers they should go above the flat washer and below the bolt head (or nut) Usually the wrenching surface (bolt head or nut) with the washer is held and the nut ot bolt head is tightened. What is the purpose of the washer? You don't show any nut in your picture, so what's the screw doing?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |